Fixing And Moving On

I got towards the beginning of the mistake .....

This did get tricky.  The clover repeat above (round 8) was untied to use the thread to tie in and finish off. this was done first. The rings by the pink shuttle were cut about 2 rings out to where I could undo the rings for extra thread to tie on shuttles to be on round 9 

So now I began mostly where I left off on round 9 it was pressed here with an iron but ...

I felt the center needed I little pining with water before I go any further. I just wanted this done so it will relax before I go on it will not be this tight when pins are remove.